OMG problem with mir3multitool... Help Ida or someone PLZZZ
- Thread starter yajim
- Start date
Click on the Settings Tab.. then click the Test Connection button. If that gives you a "X" then you aint got the right settings.
If it gives you a tick, then something is wrong with your StdItems table. There is a comment on the Multitool thread where someone else had had a problem with the StdItems table due to a missing field.
P.S.
This could do with moving to the Multitool thread, if a Mod will please oblige.
If it gives you a tick, then something is wrong with your StdItems table. There is a comment on the Multitool thread where someone else had had a problem with the StdItems table due to a missing field.
P.S.
This could do with moving to the Multitool thread, if a Mod will please oblige.
Upvote
0
Depends if you used the right buttons.
Your StdItems numbers MUST be consecutive, you cannot just delete some.
Oh.. and ..
If you try to Add an item that has the same number as one that already exists, it will screw up all your DB's (This check isn't in the tool, so beware!).
Your StdItems numbers MUST be consecutive, you cannot just delete some.
Oh.. and ..
If you try to Add an item that has the same number as one that already exists, it will screw up all your DB's (This check isn't in the tool, so beware!).
Upvote
0
Does your Item table have "OrgName" as a field? If not, you will need to add it, either that or edit the vb6 files that come with that release and remove those lines of the code so it doesn't read it.
This is posted somewhere in the thread where that tool is released.
This is posted somewhere in the thread where that tool is released.
Upvote
0