Cannot find map >_<

[Kick]

After starting up the eiserver.exe it says:
"File not foundC:\myclientfoldername...

Some of the map names are such as "CUSTOM2.map". I remember from saetting up mir2 server that you could go into a .txt file and delete some map names so it wont try to find them when it boots up, is it possible to do the same with mir3?

Any help is appreciated thanks

 

[wazz]

i guess so, just go into the same section as Mir2.


C:\Mud3\Mir300\Envir\MapInfo.txt

 

[Lucard]

If you have the MSRB2.9 server stuff, in the client folder is a file (Client2.9Alpha.exe) that contains the missing maps except for 9.map.

 

[Kick]

Ok so i extracted the maps from the Client2.9Alpha.exe into client map folder and deleted the ones which couldn't be found in the mapinfo.txt.


I also changed MirF in client folder to:

[Initial]
ServerAddr=24.165.93.48
Param1=7000
Param2=http://www.google.com/
Param3=http://www.google.com/
Param4=
Param5=

[Server]
ServerCount=1
server1caption=ktest
server1name=ktest

Mir3patch to:

[PATCH_FTP]
ServerIP=127.0.0.1
Port=21
userid=userid
passwd=password
BaseDirectory=autopatch/
ListFile=!plist2.lst

And mir3 to:

[Initial]
ServerAddr=127.0.0.1
Param1=7000
Param2=
Param3=
Param4=
Param5=

[Server]
ServerCount=1
server1caption=ktest
server1name=ktest

(They were set up to be used with fantasy server)

The DBSvr.exe boots up and you have to click the blue triangle to start it up
and it says:
"[Win32 error]The system cannot find the file specified.....Db server finalized"

Then eiserver.exe boots up and looks ok, but i'm stuck as to what to do next.
I tried the mir3.exe in client folder and it starts up with the movie and a little EIServer icon in the top right corner and two spaces at the bottom of the page where you type in id /password etc (but no words indicating that's where you type them in, maybe some kinda error?)
Then after a few seconds a box pops up with korean writing at the top and says:
"A connection attempt failed because the connected party did not respond properly after a period of time, or established connection has failed because connected host has failed to respond"

Am i using the correct mir3.exe or do i have to extract one from elsewhere?
Sorry for the length just wanted to make sure i filled you in properly

Thanks in advance for your help