Plumewind Confirmation denied - No Notice (Black Screen)

[who8myrice]

Dear Users.

I am setting up a server 1.9, everything is running fine (I think). However, after the character selection screen, the notice does not come up and remains at a black screen. This problem does not occur when it is offline.

I am suspecting that it is a problem with Plumewind V2, since after M2Server is loaded, a line of "Confirmation denied" is shown at the Plumewind application.

UNPNP is disabled.
IPs should be correct.
I am not using a router.
IP Obtained from www.whatismyip.com
All IPs changed to 217.44.70.35 apart from shown below, 127.0.0.1

DBSrv
[Reg]
Key=20FC20FC5447
ServerAddr=217.44.70.35
ServerPort=63000

!Setup
[Reg]
ServerAddr=217.44.70.35
Key=20FC20FC5447
IP=127.0.0.1
ServerPort=63000

I had put a lot of effort in sorting this out and had done a lot of search in this forum before I decided to post it up, which was my last resort. I hope that someone can help, Thank you.

 

[who8myrice]

Here are some photos which could help.

I currently run Ledu Confirm V2 (Plumewind), DBServer, GameGate, LoginGate, LoginSrv, LogServer, SelGate then M2Server (Plumewind).
I then load the Game Client.exe

In addition, I just want to ask wheather the bright flames of the MirArmour and the wings of the HeavenArmour could show on the back of the player? In my game, it only shows it in the dressing box (where item is put on), but not on the actual player (moving character). If so, how could I do it?

 

[Hazuki]

Try on the M2Server (c) then Gate i think it is and open, then the gates should open allowing you to get ingame.

 

[Ragnar]

Try on the M2Server (c) then Gate i think it is and open, then the gates should open allowing you to get ingame.

The M2Server does that automatically usually (yes there has been exceptions) but in this case, it did, and the confirmation request was denied.

Change the reg bit to this, and try again.

[Reg]
Key=20FC20FC5447
IP=127.0.0.1
ServerAddr=127.0.0.1
ServerPort=63000

 

[who8myrice]

[Reg]
Key=20FC20FC5447
IP=127.0.0.1
ServerAddr=127.0.0.1
ServerPort=63000When !setup is changed to this, using two of the same IPs (127.0.0.1), The problem still exist, with black screen after character selection screen. Further more, after the changing of IPs I don't think the Plumewind V2 is detecting the connection, as there are no successful confirmation nor denies.

 

[Nitro1]

what happened to me once was if i was running on Windows XP that happened and i changed to widows ME and it worked but there are more reasons try searching on google

 

[MentaL]

happend to me on my other pc, turns out i was using the wrong ip :P

 

[Zidio]

check i.p`s and server names if your are useing norton disbale norton internet secuirity for 5 mins to enable Gate [0] to open if not diasble it and open the gate as post above ^^

 

[lifco]

are u usein a server start prog ? if so make sure GateAddr=0.0.0.0 in your LoginGate / config.ini and allso the logserver / logserver.ini says MonAddr=0.0.0.0
Selgate / config.ini says GateAddr=0.0.0.0

lif

 

[who8myrice]

Thanks guys... works fine now